Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1991SONATA V6-3.0LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMNEUTRAL SAFETY SWITCHSERVICE AND REPAIR
1991 Hyundai Sonata V6-3.0L
Neutral Safety Switch: Service and Repair
1991 Hyundai Sonata V6-3.0LSECTION Service and Repair
Fig. 1 Adjusting Neutral Start (Inhibitor) Switch:
1. Place manual control lever in Neutral position, then remove control lever retainer and control lever.
2. Disconnect electrical harness, then remove switch retaining bolts and switch assembly.
3. Reverse procedure to install, then adjust switch as follows:
a. With manual control lever in Neutral position, turn switch body until wide end (A) of control lever, Fig. 1, overlaps switch body flange.
b. Hold switch body in position, then torque retaining bolts to 8 ft. lbs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.