Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1991SONATA V6-3.0LREPAIR AND DIAGNOSISMAINTENANCETECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSWHEEL ALIGNMENT - CORRECTED SPECIFICATIONS
1991 Hyundai Sonata V6-3.0L
Wheel Alignment - Corrected Specifications
1991 Hyundai Sonata V6-3.0LSECTION Wheel Alignment - Corrected Specifications
90hyundai03
Group CHASSIS
Number 009
Date DECEMBER, 1990
Model ALL
WHEEL ALIGNMENT SPECIFICATIONS
The rear wheel toe specification for 1990 and 1991 MY Excel and Scoupe has been corrected.
WAS: 0 + O.1 mm
- 0.05 mm
NEW: 0 + 6 mm
- 3 mm
Full wheel alignment specifications are given below. These specifications supersede all previous specifications. Please make these changes in your Shop Manuals and Service Data Books.
1) EXCEL (For 90 Model Year and Later)
1990 and 1991 Excel Shop Manual - Page 55-2 and 55-6. 1990 Excel Service Data Book - Page 55-1.
2) SCOUPE
1991 Scoupe Shop Manual - Page 55-2 and 55-6
3) SONATA & V6 (1989 Model Year and Later)
*: Camber angle difference between LH and RH wheel should not be more than 30'.
NOTE: Front wheel camber and caster are not adjustable. Rear wheel alignment settings are not adjustable.
Group CHASSIS
Number 009
Date DECEMBER, 1990
Model ALL
WHEEL ALIGNMENT SPECIFICATIONS
The rear wheel toe specification for 1990 and 1991 MY Excel and Scoupe has been corrected.
WAS: 0 + O.1 mm
- 0.05 mm
NEW: 0 + 6 mm
- 3 mm
Full wheel alignment specifications are given below. These specifications supersede all previous specifications. Please make these changes in your Shop Manuals and Service Data Books.
1) EXCEL (For 90 Model Year and Later)
1990 and 1991 Excel Shop Manual - Page 55-2 and 55-6. 1990 Excel Service Data Book - Page 55-1.
2) SCOUPE
1991 Scoupe Shop Manual - Page 55-2 and 55-6
3) SONATA & V6 (1989 Model Year and Later)
*: Camber angle difference between LH and RH wheel should not be more than 30'.
NOTE: Front wheel camber and caster are not adjustable. Rear wheel alignment settings are not adjustable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.