SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2020PILOT LX, FWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY SYSTEM KEYLESS ENTRY SYSTEM - TESTING & TROUBLESHOOTING (1 OF 2)SYSTEM DESCRIPTIONKEYLESS/POWER DOOR LOCKS/SECURITY - CONTROL/FUNCTIONSECURITY CONTROLSECURITY SYSTEM OPERATING TERM
2020 Honda Pilot LX, FWD

Security system operating term

2020 Honda Pilot LX, FWDSECTION Security system operating term
Start setting
  • Lock the door using a mechanical key
  • Lock the door by using the remote
  • Lock the door by pressing the door outer handle lock switch while having the remote
  • Operate a keyless relock
Cancellation
  • Unlock the door using a mechanical key
  • Unlock the door by using the remote
  • Unlock the door by pressing the door outer handle lock switch or tailgate outer handle switch while having the remote
  • Press the engine start/stop switch button while having the remote
Setting conditions (related systems are normally operated)
  • Door switch OFF (Door close)
  • Door unlock knob switch OFF (Lock)
  • Tailgate latch switch*2 or full latch switch*1 OFF (Tailgate close)
  • Driver's door key cylinder switch OFF
  • Security hood switch ON (Hood close)
  • Vehicle OFF (LOCK) mode
  • Shift P position/mode (6-speed A/T only)
Start the alarm When any of the monitoring switch signal inputs are received without the signal for cancelling setting
Cancel the alarm Compliant with the conditions for cancelling setting

*1: With power tailgate

*2: Without power tailgate

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.