DTC P2227

2020 Honda HR-V LX, FWDSECTION DTC P2227

DTC P2227  : BARO Sensor Circuit Range/Performance Problem

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC Description Confirmed DTC Pending DTC Freeze Frame
P2227 BARO Sensor Circuit Range/Performance Problem      

DTC (PGM-FI)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P2227 BARO Sensor Circuit Out of Range High      

    Is DTC P2227 indicated?

    YES 

    The failure is duplicated. Update the PCM if it does not have the latest software, or substitute a known-good PCM , then recheck. If DTC P2227 goes away and the PCM was updated, troubleshooting is complete. If DTC P2227 goes away and the PCM was substituted, replace the original PCM .

    NO 

    Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.