DTC P06A8

2020 Honda HR-V LX, FWDSECTION DTC P06A8

DTC P06A8  : Internal VCC Power Malfunction

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC Description Confirmed DTC Pending DTC Freeze Frame
P06A8 Internal VCC Power Malfunction      

DTC (PGM-FI)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Reset the PCM with the HDS .

    Reset PCM

    -3. Turn the vehicle to the OFF (LOCK) mode.

    -4. Turn the vehicle to the ON mode.

    -5. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P06A8 Internal VCC Power Malfunction      

    Is DTC P06A8 indicated?

    YES 

    The failure is duplicated. Update the PCM if it does not have the latest software, or substitute a known-good PCM , then recheck. If DTC P06A8 goes away and the PCM was updated, troubleshooting is complete. If DTC P06A8 goes away and the PCM was substituted, replace the original PCM .

    NO 

    Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.