DTC P065A

2020 Honda HR-V LX, FWDSECTION DTC P065A

DTC P065A  : ACG No Charging Malfunction

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC Description Confirmed DTC Pending DTC Freeze Frame
P065A ACG No Charging Malfunction      

DTC (PGM-FI)

  1. DTC check

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Start the engine, and let it idle for 1 minute.

    -4. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P0562 Charging System Low Voltage      

    Is DTC P0562 indicated?

    YES 

    Do the troubleshooting for DTC P0562 .

    NO 

    Go to step 2.

  2. Problem verification

    -1. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P065A ACG No Charging Malfunction      

    Is DTC P065A indicated?

    YES 

    The failure is duplicated. Go to step 3.

    NO 

    Intermittent failure, the system is OK at this time. Check the alternator and the drive belt. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot .

  3. Drive belt check

    -1. Inspect the drive belt .

    Is the drive belt OK?

    YES 

    Repair or replace the alternator .

    NO 

    Replace the drive belt .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.