DTC P0507

DTC P0507:  Idle Control System RPM Higher Than Expected

General Description 

Courtesy of HONDA, U.S.A., INC.

Courtesy of HONDA, U.S.A., INC.

A target idle speed that meets the engine operating conditions (coolant temperature, A/C ON or OFF, etc.) is stored in the powertrain control module (PCM). The PCM monitors and controls the idle speed so that the actual idle speed is equal to the target idle speed. If the actual idle speed varies beyond a specified value from the target speed over a certain period of time, the PCM detects a malfunction in the idle speed control system and stores a DTC.

Monitor Execution, Sequence, Duration, DTC Type 

Execution	Once per driving cycle
Sequence	None
Duration	24 seconds or more
DTC Type	Two drive cycles, MIL on

Enable Conditions 

Condition	Minimum	Maximum
Engine coolant temperature [ECT SENSOR 1]	156 deg. F (69 deg. C)	-
Intake air temperature [IAT SENSOR (1)]	19 deg. F (-7 deg. C)	-
12 volt battery voltage [BATTERY]	10.5 V	-
Fuel trim	0.69	1.47
Throttle position	Fully closed
Fuel feedback	Closed loop
Other	The engine is under no load

[ ]: HDS Parameter

Malfunction Threshold 

The actual idle speed is 200 rpm greater than the target idle speed for at least 24 seconds.

Possible Cause 

NOTE:  The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.

• Throttle body air leak
• Intake manifold air leak
• Intake air system air leak

Confirmation Procedure 

Operating Condition 

• Start the engine. Hold the engine speed [ENGINE SPEED] at 3, 000 rpm without load (CVT in P or N, M/T in neutral) until the radiator fan comes on.
• Let the engine idle for at least 24 seconds.

With the HDS 

None.

Diagnosis Details 

Conditions for setting the DTC 

When a malfunction is detected during the first drive cycle, a Pending DTC is stored in the PCM memory. If the malfunction returns in the next (second) drive cycle, the MIL comes on and a Confirmed DTC and the freeze data are stored.

Conditions for clearing the DTC 

The MIL is cleared if the malfunction does not return in three consecutive trips in which the diagnostic runs. The MIL, the Pending DTC, the Confirmed DTC, and the freeze data can be cleared with the scan tool Clear command or by disconnecting the 12 volt battery.