Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Lane Keeping Assist System (LKAS) Symptom Troubleshooting - LKAS activation indicator (on the MID) does not come on
- Gauge control module operation check
-1. Do the gauge control module self-diagnostic function .
Is the gauge control module OK?
YES
Go to step 2.
NO
- ACC combination switch check
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Test the ACC combination switch .
Is the switch OK?
YES
Go to step 3.
NO
- Open wire check (CRUISE SW line)
-1. Disconnect the following connector.
ACC combination switch 12P connector -2. Turn the vehicle to the ON mode.
-3. Measure the voltage between test points 1 and 2.
Test condition Vehicle ON mode ACC combination switch 12P connector: disconnected Test point 1 ACC combination switch 12P connector No. 6 Test point 2 Body ground Is there about 5 V?
YES
Repair an open in the CRUISE GND wire between the ACC combination switch and the gauge control module.
NO
Repair an open in the CRUISE SW wire between the ACC combination switch and the gauge control module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.