Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B1C63
DTC B1C63 : Passenger's Heater Current Abnormal Low
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
- The front seat heater control unit does not turn on the front seat heater until the seat core temperature is 185°F (85°C) or less. Make sure the seat core temperature is below 185°F (85°C) before troubleshooting.
| DTC Description | DTC |
|---|---|
| B1C63 Passenger's Heater Current Abnormal Low |
DTC (Front Seat Heater Control Unit)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Check for DTCs with the HDS.
DTC Description DTC B1C63 Passenger's Heater Current Abnormal Low Is DTC B1C63 indicated?
YES
Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.
- DTC check
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Disconnect the following connector.
Front passenger's seat cushion heater 4P connector -3. Connect terminals A and B with a jumper wire.
Terminal A Front passenger's seat cushion heater 4P connector No. 1 Terminal B Body ground -4. Turn the vehicle to the ON mode.
-5. Clear the DTCs with the HDS.
-6. Check for DTCs with the HDS.
DTC Description DTC B1C63 Passenger's Heater Current Abnormal Low Is DTC B1C63 indicated?
YES
Repair an open or high resistance in the +B HEATER(AS) wire.
NO
Go to step 3.
- Seat heater check
-1. Disconnect the following connector.
Front passenger's seat-back heater 2P connector -2. Measure the resistance between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode
Front passenger's seat cushion heater 4P connector: disconnected
Front passenger's seat-back heater 2P connector: disconnectedTest point 1 Front passenger's seat cushion heater 4P connector No. 1 Test point 2 Front passenger's seat cushion heater 4P connector No. 2 Is there more than 6.1 Ω?
YES
Replace the front passenger's seat cushion heater .
NO
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.