Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
VSA Sensor Neutral Position Memorization: Procedure
NOTE:
- The VSA sensor neutral position must be learned whenever you do any of these actions:
-
- -
Update or replace the VSA modulator-control unit.
- -
-
- -
Update or replace the SRS unit.
- -
-
- -
Remove the steering wheel.
- -
-
- -
Disconnect the steering joint.
- -
-
- -
Wheel alignment adjustment.
- -
- Before doing the memorization procedure, park the vehicle on a flat and level surface.
- After doing the VSA sensor neutral position memorization, do the related procedure(s).
- HDS - Connect
- VSA Sensor Neutral Position - Memorize
NOTE: Do not press the brake pedal during this procedure. 1. Set the steering wheel in the straight ahead position.
2. Select the ADJUSTMENT from the ABS/TCS/VSA menu with the HDS, then select ALL SENSOR, and follow the screen prompts.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.