Engine Oil Level Check and Replacement: Replacement

NOTE: How to read the torque specifications .

1. Engine - Warm Up

   1. Enter the maintenance mode, then start the engine . Allow the engine to reach operating temperature (fan comes on at least twice).

2. Vehicle - Lift
3. Engine Oil - Drain
   Fig 1: Engine Oil Drain Plug Components With Torque Specifications

   Courtesy of HONDA, U.S.A., INC.

   1. Remove the drain bolt (A), and drain the engine oil. 2. Reinstall the drain bolt with a new washer (B) and torque to specification.

4. Engine Oil - Refill

   Courtesy of HONDA, U.S.A., INC.

   1. Refill the engine with the recommended engine oil .

   Capacity
   At Oil Change:	3.5 L (3.7 US qt)
   At Oil Change including Filter:	3.8 L (4.0 US qt)
   After Engine Overhaul:	4.5 L (4.8 US qt)

5. Engine Oil Level - Check

   1. Enter the maintenance mode, then start the engine . Run the engine for more than 3 minutes, then check the oil level and the oil leakage.

6. Maintenance Minder - Reset

   1. If the Maintenance Minder required to replace the engine oil, reset the Maintenance Minder with the gauge (see "Resetting the Maintenance Minder"). If the Maintenance Minder did not require to replace the engine oil, reset the Maintenance Minder with the HDS (see "Resetting the Individual Maintenance Items").