Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U3000-51 (Gauge Control Module)
DTC U3000-51 : Reprogramming error
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
- Before reprogramming the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a 12 volt battery charger) to maintain system voltage.
- Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, during the reprogramming. If there is a problem with the reprogramming, turn the vehicle to the ON mode.
| DTC Description | DTC |
|---|---|
| U3000-51 Reprogramming error |
DTC (Gauge Control Module)
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Check for DTCs with the HDS.
DTC Description DTC U3000-51 Reprogramming error Is DTC U3000-51 indicated?
YES
Reprogramming the gauge control module.
NO
Intermittent failure, the system is OK at this time.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.