Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U1280 (Keyless Access Power Control Unit)
DTC U1280 : B-CAN communication bus line error (BUS-OFF)
| DTC Description | DTC |
|---|---|
| U1280 B-CAN communication bus line error (BUS-OFF) |
DTC (Power Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A .
- Problem verification
-1. Clear the DTCs with the HDS.
Clear DTCs
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Wait for at least 6 seconds.
-4. Check for DTCs with the HDS.
DTC Description DTC U1280 B-CAN communication bus line error (BUS-OFF) Is DTC U1280 indicated?
YES
Go to MICU DTC U1280 troubleshooting .
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.