2014 Honda Pilot EX, FWDFACTORY OEM SERVICE PROCEDURE

Combination Switch Control Unit Input Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2014 Honda Ridgeline, 2013 Honda Ridgeline, 2012 Honda Ridgeline, 2011 Honda Ridgeline, and 2010 Honda Ridgeline. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Check the No. 22 (120 A) No. 23 (60 A), No. 15(40 A) fuse in the under-hood fuse/relay box before testing.
  1. Before troubleshooting the combination switch control unit, troubleshoot the multiplex integrated control system first, using B-CAN System Diagnosis Test mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE AΒ ).
  2. Turn the ignition switch to LOCK (0).
  3. Remove the steering column covers (see REMOVAL ).
  4. Disconnect the 12P connector from the combination switch control unit.
    Fig 1: Identifying Combination Switch Control Unit 12P Connector Terminals
    G05968652Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, Go to step 6.
  6. Reconnect all the connector to the control unit, and do the following input tests:
  • If any test indicates a problem, find and correct the cause, then recheck the system.
  • If all the input tests prove OK, the combination switch control unit must be faulty, replace the combination switch (see COMBINATION SWITCH REPLACEMENT ).
WIRE TEST CONDITION REFERENCE CHART

Cavity Wire Test condition Test: Desired result Possible cause if desired result is not obtained
12 BLK In all ignition switch positions Measure the voltage to ground:
There should be less than 0.2 V.
  • Poor ground(G401)
  • An open or high resistance in the ground wire
7 WHT/RED Under all conditions Measure the voltage to ground:
There should be battery voltage.
  • Blown No. 7 (7.5 A) fuse in the under-dash fuse/relay box
  • An open or high resistance in the wire
1 YEL Ignition switch ON (II) Measure the voltage to ground:
There should be battery voltage.
  • Blown No. 21 (7.5 A) fuse in the under-dash fuse/relay box
  • An open or high resistance in the wire
3 LT GRN Under all conditions Check for continuity between terminal No. 3 and under-dash fuse/relay box connector X (39P) terminal No. 27:
There should be continuity.
An open or high resistance in the wire
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.