2014 Honda Pilot EX, FWDFACTORY OEM SERVICE PROCEDURE

Fuel Tank Replacement

  1. Drain the fuel tank (see FUEL TANK DRAININGΒ  ), then reinstall the fuel tank unit without connecting the fuel tank unit 4P connector and the fuel tank unit quick-connect fitting.
  2. Raise the vehicle on a lift.
  3. Remove the exhaust pipe (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
  4. With VTM-4: Remove the propeller shaft (see PROPELLER SHAFT RUNOUT ).
  5. Remove the EVAP canister cover (see step 2 under FTP SENSOR REPLACEMENT ).
  6. Remove the fuel tank protector (A).
    Fig 1: Fuel Tank Protector And Fuel Tank Replacement Components With Torque Specifications
    G08079419Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Disconnect the quick-connector fittings (B) and the hoses (C). Slide back the clamps, then twist the hoses as you pull to avoid damaging them.
  8. Place a jack or other support under the fuel tank (D), then remove the strap bolts (E) and the straps (F).
  9. Remove the fuel tank.
  10. Install the parts in the reverse order of removal.
    Fig 2: Installing Fuel Tank Parts
    G08079420Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.