Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Honda Pilot EX, FWDFACTORY OEM SERVICE PROCEDURE
Driver's Power Window Motor Test
Motor Test
- Remove the power window master switch (see POWER WINDOW MASTER SWITCH REPLACEMENT ).
- Test the motor in each direction by connecting battery power and ground to the power window master switch 37P connector (A) according to the table.
Terminal 12 24 Direction UP (+) (-) DOWN (-) (+) - If the motor does not run or fails to run smoothly, go to step 4, if the motor runs smoothly, go to step 8.
- Remove the door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the 6P connector (A) from the driver's power window motor (B).
- Check for continuity between power window master switch 37P connector terminals No. 12 and No. 24 and driver's power window motor 6P connector terminals No. 1 and No. 4 respectively. There should be continuity.
POWER WINDOW MASTER SWITCH 37P CONNECTOR
Terminal No. 12
Terminal No. 24
DRIVER'S POWER WINDOW MOTOR 6P CONNECTOR
Terminal No. 4
Terminal No. 1
- If there is no continuity, repair an open or high resistance in the wires. If the wire harness in OK, replace the driver's power window motor (see
FRONT DOOR GLASS AND REGULATOR REPLACEMENT
).
Hall IC unit (Pulser) Test
- Check for continuity between driver's power window motor 6P connector terminal No. 2 and body ground. There should be continuity.
- If there is continuity, go to step 9.
- If there is no continuity, check for an open or high resistance in the BLK wire or poor ground (G401).
- Do the power window master switch input test at terminals No. 3, No. 20, No. 22 and No. 32 (see POWER WINDOW MASTER SWITCH INPUT TEST ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
