Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Signal Circuit Troubleshooting
- Start the engine, and let it idle.
- Turn the blower switch on.
- Turn the A/C switch on.
- Check the A/C CLUTCH in the DATA LIST with the HDS.
Does it indicate ON?
YES -Go to step 5.
NO -Do the A/C system test (see A/C SYSTEM TEST ).
- Check the A/C system.
Does the A/C system operate?
YES -The A/C signal circuit is OK.
NO -Go to step 6.
- Turn the ignition switch to LOCK (0).
- Turn the ignition switch to ON (II).
- Activate the A/C CLUTCH in the INSPECTION MENU with the HDS.
Is there a clicking noise from the A/C compressor clutch?
YES -Do the A/C system test (see A/C SYSTEM TEST ).
NO -Go to step 9.
- Turn the ignition switch to LOCK (0).
- Jump the SCS line with the HDS.
- Disconnect PCM connector A (49P).
- Turn the ignition switch to ON (II).
- Momentarily connect PCM connector terminal A41 to body ground with a jumper wire several times.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there a clicking noise from the A/C compressor clutch?
YES -Update the PCM if it does not have the latest software (see PCM UPDATE ), or substitute a known-good PCM (see SUBSTITUTING THE PCM ), then recheck. If the symptom/indication goes away and the PCM was updated, troubleshooting is complete. If the symptom/indication goes away and the PCM was substituted, replace the original PCM (see PCM REPLACEMENT ).
NO -Check for poor connections or loose terminals at the A/C compressor clutch relay and the PCM. If the connections and the terminals are OK, check the A/C compressor clutch relay (see POWER RELAY TEST ). If needed, repair an open in the wire between the PCM (A41) and the A/C compressor clutch relay, or in other A/C parts.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.