Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Honda FitFACTORY OEM SERVICE PROCEDURE
HandsFreeLink Control Unit DTC Index
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
HandsFreeLink Control Unit (2012 Model Without Navigation)
NOTE:
For HandsFreeLink diagnostic trouble codes, refer to the HANDSFREELINK system article.
HANDSFREELINK CONTROL UNIT DTC TROUBLESHOOTING TABLE
| DTC | Description | DTC type |
|---|---|---|
| B1775 | Microphone input/output shorted to power or open | Signal Error |
| B1776 | Microphone input/output shorted to ground | Signal Error |
| B1779 | HandsFreeLink steering wheel switch failure | Signal Error |
| B1780 | HandsFreeLink steering wheel switch line short | Signal Error |
| B1792 | HandsFreeLink control module error | Signal Error |
| U1280 | Communication bus line error (BUS-OFF) | Loss of communication |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.