2012 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE

Driver's Power Window Motor Test

Motor Test 

  1. Remove the power window master switch panel (see POWER WINDOW MASTER SWITCH REPLACEMENT  ).
  2. Test the motor in each direction by connecting battery power and ground to the power window master switch 37P connector (A) according to the table.
    Fig 1: Power Window Master Switch Connector Terminal Continuity Chart
    G06969865Courtesy of AMERICAN HONDA MOTOR CO.,INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.