2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Symptom Troubleshooting Index

TROUBLESHOOTING TABLE

Symptom Diagnostic procedure Also check for
Engine does not start (does not crank)
  1. Check for loose battery terminals or connections.
  2. Test the battery for a low state of charge (see BATTERY TEST ).
  3. Check the starter (see STARTER SYSTEM CIRCUIT TROUBLESHOOTINGΒ  ).
  4. Check the starter cut relay (see POWER RELAY TEST ).
  5. Check the transmission range switch (A/T model) (see TRANSMISSION RANGE SWITCH TEST ).
  6. Check the clutch interlock switch (M/T model) (see CLUTCH INTERLOCK SWITCH TESTΒ  ).
  7. Check the ignition switch or related circuits (see TEST ).
  • Poor ground at G101 (A/T model), G401 (M/T model)
  • Seized engine
Engine cranks, but does not start
  1. Check for PGM-FI DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  2. Check the fuel pressure (see FUEL PRESSURE TEST ).
  3. Check the ignition system.
  4. Check for a plugged or damaged fuel line (see FUEL LINE INSPECTION ).
  5. Check for a plugged fuel filter (see FUEL PRESSURE REGULATOR REPLACEMENT ).
  6. Check the throttle body (see THROTTLE BODY TEST ).
  7. Check for low engine compression (see ENGINE COMPRESSION INSPECTION ).
  8. Check for a damaged or broken cam chain.
  9. Do the engine control module (ECM)/powertrain control module (PCM) reset function with the Honda Diagnostic System (HDS) to cancel the ALL INJECTORS STOP function.
  • Weak or fouled spark plugs
  • Poor quality fuel
Engine is hard to start
  1. Check for PGM-FI DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  2. Check the fuel pressure (see FUEL PRESSURE TEST ).
  3. Check for a plugged or damaged fuel line (see FUEL LINE INSPECTION ).
  4. Check for a plugged fuel filter (see FUEL PRESSURE REGULATOR REPLACEMENT ).
  • Weak or fouled spark plugs
  • Poor quality fuel
Engine cranks slowly
  1. Check for loose battery terminals or connections.
  2. Test the battery for a low state of charge (see BATTERY TEST ).
  3. Check the starter for binding (see STARTER OVERHAULΒ  ).
  4. Check for excessive drag in the engine.
-
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.