Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
MICU Input Test
NOTE:
- Before testing, check the No. 1 (10 A), No. 20 (15 A), No. 22 (7.5 A), No. 27 (30 A), No. 35 (10 A), No. 36 (15 A), No. 38 (15A), No. 49 (15 A), No. 50 (15 A), and No. 60 (50 A) fuses in the under-dash fuse/relay box.
- There are two pairs of fuses in the same circuit (No. 35 and No. 49 fuses, No. 36 and No. 50 fuses). If one of the fuses is blown, check the another fuse in the same circuit. If necessary, replace the damaged fuse(s).
- Turn the ignition switch to LOCK (0).
- Remove the fuse access panel (see FUSE ACCESS PANEL REMOVAL/INSTALLATION ).
- Disconnect under-dash fuse/relay box connectors A, B, C, E, F, K, M, N, Q, and W.NOTE: All connector views are shown from wire side of female terminals.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
