Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Keyless/Power Door Locks/Security System
- Component Location Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- DTC B1127: Driver's Door Key Cylinder Switch Input Circuit Malfunction (Simultaneous Input Of Lock and Unlock Signal)
- DTC B1128: Driver's Door Remote Switch Input Circuit Malfunction (Simultaneous Input Of Lock and Unlock Signal)
- DTC B1129: Driver's Door Lock Knob Switch Input Circuit Malfunction (Simultaneous Input Of Lock and Unlock Signal)
- Symptom Troubleshooting Index
- Symptom Troubleshooting
- Doors Automatically Relock 30 Seconds After Being Unlocked With the Transmitter Even Though a Door Has Been Opened
- Keyless Operation Does Not Work (LOCK, UNLOCK, PANIC)
- Doors Will Not Unlock (Or Lock) With the Transmitter, But Will Unlock (Or Lock) With the Door Lock Switch And the Door Key Cylinder Switch
- The Horn Does Not Sound And/Or the Headlights Do Not Flash When the PANIC Button On the Transmitter Is Pressed
- Security Alarm System Will Not Arm
- Notes
- Tailgate Latch Switch Circuit Troubleshooting
- Security Hood Switch Circuit Troubleshooting
- Driver's Door Lock Knob Switch Circuit Troubleshooting
- Passenger's Door Lock Knob Switch Circuit Troubleshooting
- Left Rear Door Lock Knob Switch Circuit Troubleshooting
- Right Rear Door Lock Knob Switch Circuit Troubleshooting
- Driver's Door Switch Circuit Troubleshooting
- Passenger's door switch circuit troubleshooting
- Left Rear Door Switch Circuit Troubleshooting
- Right Rear Door Switch Circuit Troubleshooting
- Driver's Door Key Cylinder Switch Circuit Troubleshooting
- MICU Input Test
- Door Lock Actuator Test
- Tailgate Lock Actuator Test
- Door Lock Knob Switch Test
- Door Key Cylinder Switch Test
- Security Horn Test/Replacement
- Security Hood Switch Test
- Transmitter Test
- Tripped Sensor History
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
