Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESHIFT INTERLOCKSERVICE AND REPAIR
2010 Honda Crosstour 2WD V6-3.5L
Shift Interlock: Service and Repair
2010 Honda Crosstour 2WD V6-3.5LSECTION Service and Repair
Shift Lock Stop/Shift Lock Stop Cushion Replacement
1. Remove the shift lever assembly A/T Shift Lever Removal.
2. Remove the A/T gear position indicator panel from the shift lever.
3. Release the lock tab (A) retaining the shift lock solenoid using a thin-bladed screwdriver.
4. Remove the shift lock stop (B) and the stop cushion (C) as a set.
5. Apply silicone grease to the pin (D) of the shift lever bracket, then install the shift lock stop over the pin.
NOTE: Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.
6. Install the shift lock stop.
7. Install the shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock stop, then push the shift lock solenoid into the shift lever securely.
8. Install the A/T gear position indicator panel on the shift lever.
9. Install the shift lever assembly A/T Shift Lever Installation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.