Removal and Replacement

Alternator Removal and Installation

Removal

1. Do the battery terminal disconnection procedure Procedures.

2. Raise the vehicle on the lift.

3. Remove the engine undercover.

4. Disconnect the A/C condenser fan motor connector (A) and remove the harness clamp (B).





5. Loosen the A/C condenser fan shroud mounting bolts (C).

6. Lower the vehicle on the lift.

7. Remove the coolant reservoir (A), then remove the A/C condenser fan shroud assembly (B).






8. Remove the drive belt:

- '10 model Service and Repair

9. Disconnect the alternator connector (A) and the positive alternator cable (B) from the alternator.





10. Remove the harness clamp (C) from the alternator and disconnect the A/C compressor clutch connector (D) from the A/C compressor.

11. Remove the bolt (E) securing the harness holder.

12. Remove the mounting bolt (A) and the alternator bracket mounting bolt (B), then remove the alternator.






Installation

1. Install the alternator, then tighten the mounting bolt (A) and the alternator bracket mounting bolt (B).






2. Install the bolt (A) securing the harness holder.





3. Install the harness clamp (B) to the alternator and connect the A/C compressor clutch connector (C) to the A/C compressor.

4. Connect the alternator connector (D) and the positive alternator cable (E) to the alternator. Make sure the crimped side of the ring terminal faces away from the alternator when you connect it.

5. Install the drive belt:

- '10 model Service and Repair

6. Install the A/C condenser fan shroud assembly (A), then install the coolant reservoir (B).






7. Raise the vehicle on the lift.

8. Tighten the A/C condenser fan shroud mounting bolts (A).





9. Connect the A/C condenser fan motor connector (B) and install the harness clamp (C).

10. Install the engine undercover.

11. Lower the vehicle on the lift.

12. Do the battery terminal reconnection procedure Procedures.