SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRREMOVAL AND REPLACEMENT
2010 Honda Crosstour 2WD V6-3.5L

Removal and Replacement

2010 Honda Crosstour 2WD V6-3.5LSECTION Removal and Replacement



Battery Removal and Installation

NOTE: The battery terminal disconnection and reconnection procedure Procedures must be done before and after doing this procedure. Some systems store data in memory that is lost when the battery is disconnected.

Removal

1. Do the battery terminal disconnection procedure.

2. Remove the clip and splash separator (A).






3. Remove the two nuts (B) securing the battery setting plate (C), then remove the battery setting plate and the battery (D).

Installation

1. Install the battery (A), then install the battery setting plate (B).





2. Tighten the two nuts (C) equally until the battery is stable.

NOTE: Do not deform the battery setting plate by over-tightening the nuts.

3. Install the splash separator (D) and the clip.

4. Do the battery terminal reconnection procedure.

NOTE: Make sure the battery is installed correctly, and the positive terminal and the negative terminal are not reversed.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.