Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/T Gear Position Indicator Does Not Indicate Shift Lever Positions
2010 Honda Crosstour 2WD V6-3.5LSECTION A/T Gear Position Indicator Does Not Indicate Shift Lever Positions
A/T gear position indicator does not indicate shift lever positions
Transmission range switch defective or out of adjustment
Shift cable broken or out of adjustment
Connection between shift cable and transmission or shift lever is worn
Notes
Inspect the transmission range switch. If the transmission range switch fails the inspection, replace the switch. If the inspection is OK, check for proper transmission range switch installation, and adjust the shift cable.
Notes
Check for a loose shift cable at the shift lever and the selector control lever.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.