Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISMAINTENANCEDRIVE BELTTESTING AND INSPECTION
2010 Honda Crosstour 2WD V6-3.5L
Drive Belt: Testing and Inspection
2010 Honda Crosstour 2WD V6-3.5LSECTION Testing and Inspection
Drive Belt Inspection
'10 model
1. Inspect the belt for cracks or damage. If the belt is cracked or damaged, replace it Service and Repair.
2. Check that the position of the auto-tensioner indicator pointer (A) on the A/C compressor bracket is not beyond the edge of the indicator (B) on the auto-tensioner. If the pointer is beyond the indicator, replace the drive belt Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.