Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONINTERIOR LIGHT SWITCH TEST/REPLACEMENT
2010 Honda Crosstour 2WD V6-3.5L
Interior Light Switch Test/Replacement
2010 Honda Crosstour 2WD V6-3.5LSECTION Interior Light Switch Test/Replacement
Interior Light Switch Test/Replacement
NOTE: The interior light switch is built into the moonroof switch, and it switches the front individual map light OFF and DOOR positions.
1. Remove the front individual map lights.
2. Disconnect the moonroof switch 12P connector (A) and the map light 3P connector (B).
3. Remove the moonroof switch (C) from the map light housing.
4. Check for continuity between the terminals in each switch position according to the table.
5. If the continuity is not as specified, replace the moonroof switch assembly.
6. Install the parts in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.