Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONHAZARD WARNING SWITCH TEST/REPLACEMENT
2010 Honda Crosstour 2WD V6-3.5L
Hazard Warning Switch Test/Replacement
2010 Honda Crosstour 2WD V6-3.5LSECTION Hazard Warning Switch Test/Replacement
Hazard Warning Switch Test/Replacement
1. Remove these items:
- Dashboard center vent with navigation Dashboard Vent Removal/Installation.
- Audio switch panel without navigation Audio Switch Panel Removal/Installation.
2. Remove the hazard warning switch (A).
With Navigation
Without Navigation
3. Check for continuity between the terminals in each switch position according to the table.
NOTE:
- Make sure the correct test lead (+ or -) is placed on the terminal.
- When checking for continuity across the diode, use the diode setting () on the digital volt/ohm meter to check the diode bias.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
4. If the continuity is not as specified, replace the hazard warning switch.
5. Install the switch in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.