Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESCRUISE CONTROL CANNOT BE SET
2010 Honda Crosstour 2WD V6-3.5L
Cruise Control Cannot Be Set
2010 Honda Crosstour 2WD V6-3.5LSECTION Cruise Control Cannot Be Set
Cruise control cannot be set
Check the No. A8 (20 A) fuse in the under-hood fuse/relay box, and the No. B7 (15 A) fuse in the driver's under-dash fuse/relay box.
Check for PGM-FI DTCs Initial Inspection and Diagnostic Overview.
Do the cruise control combination switch test Service and Repair.
Do the cruise control input test Cruise Control (ECM/PCM) Input Test.
Also check for
Poor ground at G501
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.