SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISCRUISE CONTROLTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCRUISE CONTROL (ECM/PCM) INPUT TEST
2010 Honda Crosstour 2WD V6-3.5L

Cruise Control (ECM/PCM) Input Test

2010 Honda Crosstour 2WD V6-3.5LSECTION Cruise Control (ECM/PCM) Input Test



Cruise Control (ECM/PCM) Input Test

NOTE: Always make sure that you have the latest HDS software.

1. Connect the HDS to the DLC.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle and the PCM. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.

4. Check for and troubleshoot any DTCs Initial Inspection and Diagnostic Overview.

5. Do the following tests while monitoring parameters in the PGM-FI DATA LIST with the HDS.

6. If the input tests prove OK, replace the PCM Service and Repair.

NOTE: Intermittent failures are often caused by loose circuit connections. While monitoring cruise control inputs, flex the circuit wires, and note if any of the test results change.









RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.