SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESNAVIGATION CANNOT CONTROL XM RADIOSYMPTOM TROUBLESHOOTING
2010 Honda Crosstour 2WD V6-3.5L

Symptom Troubleshooting

2010 Honda Crosstour 2WD V6-3.5LSECTION Symptom Troubleshooting



Navigation System Symptom Troubleshooting - Navigation cannot control XM radio

Navigation cannot control XM radio

NOTE:

- Check the vehicle battery condition first Battery Test.
- Make sure that the correct navigation DVD color and version are installed.
- Check any official Honda service website for more service information about the navigation system.

1. Turn the ignition switch to ON (II).

2. Make sure the anti-theft code for the audio system is entered.

3. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode Navigation System Diagnostic Mode.

4. Check the System Links.

Is the XM icon red?

YES -

Go to Voice guidance cannot be heard, is broken up, or there is static troubleshooting Symptom Troubleshooting.οΏ½

NO -

Go to step 5.

5. Substitute a known-good navigation unit Service and Repair.

Can the navigation system control XM radio?

YES -

Replace the original navigation unit Service and Repair.οΏ½

NO -

Replace the XM receiver XM Receiver Removal/Installation.οΏ½

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.