Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Forced Starting Of The Navigation Unit
2010 Honda Crosstour 2WD V6-3.5LSECTION Forced Starting Of The Navigation Unit
Forced Starting of the Navigation Unit
Special Tools Required
- SCS Service Connector 07PAZ-001010A
1. Turn the ignition switch to LOCK (0).
2. Remove the passenger's cargo side cover Interior Trim Removal/Installation - Cargo Area.
3. Connect the SCS service connector (A) to the navigation service check connector (B) located behind the navigation unit (C).
4. Turn the ignition switch to ON (II).
5. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the System Links menu.
NOTE: If the display fails to display the System Links screen, refer to No picture is displayed troubleshooting Symptom Troubleshooting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.