Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2010CROSSTOUR 2WD V6-3.5LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTNAVIGATION SYSTEMNAVIGATION DISPLAYSERVICE AND REPAIR
2010 Honda Crosstour 2WD V6-3.5L
Navigation Display: Service and Repair
2010 Honda Crosstour 2WD V6-3.5LSECTION Service and Repair
Navigation Display Unit Removal/Installation
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard.
- Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
1. Remove the center display visor Dashboard Center Display Visor Removal/Installation (With Navigation).
2. Remove the self-tapping screws and bolts (A), then pull out the navigation display unit (B).
3. Disconnect the connector (C), and remove the navigation display unit.
4. Install the navigation display unit in the reverse order of removal. Be careful not to drop the forward screw behind the dashboard.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.