Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING/AIR CONDITIONINGEVAPORATOR TEMPERATURE SENSOR TEST
2009 Honda S2000 Base
Evaporator Temperature Sensor Test
2009 Honda S2000 BaseSECTION Evaporator Temperature Sensor Test
- Remove the evaporator core and the evaporator temperature sensor (see BLOWER/EVAPORATOR UNIT REMOVAL/INSTALLATION ).
- Dip the sensor in ice water, and measure the resistance between its terminals.
- Then pour warm water on the sensor, and check for a change in resistance.
- Compare the resistance readings with the specifications shown in the graph; the resistance should be within the specifications.
- If the resistance is not as specified, replace the evaporator temperature sensor (see BLOWER/EVAPORATOR UNIT COMPONENT REPLACEMENT ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.