Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING/AIR CONDITIONINGA/C COMPRESSOR THERMAL PROTECTOR REPLACEMENT

2009 Honda S2000 Base

A/C Compressor Thermal Protector Replacement

2009 Honda S2000 BaseSECTION A/C Compressor Thermal Protector Replacement

Remove the bolt, the ground terminal (A), and the holder (B). Disconnect the field coil connector (C), then remove the thermal protector (D).

Fig 1: Ground Terminal, Holder, Field Coil Connector And Thermal Protector With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace the thermal protector (A) with a new one, and apply silicone grease (P/N 08798-9028) (B) to the bottom of the thermal protector.

Fig 2: Applying Silicone Grease To Bottom Of Thermal Protector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the thermal protector in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.