Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2009PILOT TOURING, 3.5 4REPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SUPPLY SYSTEMFUEL LINE/QUICK-CONNECT FITTING REMOVAL

2009 Honda Pilot Touring, 3.5 4

Fuel Line/Quick-Connect Fitting Removal

2009 Honda Pilot Touring, 3.5 4SECTION Fuel Line/Quick-Connect Fitting Removal

NOTE: Before you work on the fuel lines and fittings, read FUEL LINE/QUICK-CONNECT FITTING PRECAUTIONS .

If equipped, remove the quick-connect fitting cover from the fuel line. Raise the cover (A) from the fuel line (B), and remove it as shown below.

Fig 1: Identifying Quick-Connect Fitting Cover & Fuel Line
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Relieve the fuel pressure (see FUEL PRESSURE RELIEVING ).
Check the fuel quick-connect fittings (A) for dirt, and clean them if needed.

Fig 2: Identifying Fuel Quick-Connect Fittings (1 Of 2)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.