SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009PILOT TOURING, 3.5 4REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEM COMPONENTSSYSTEM DESCRIPTIONVSA MODULATOR-CONTROL UNIT INPUTS AND OUTPUTS FOR 36P CONNECTOR
2009 Honda Pilot Touring, 3.5 4

VSA Modulator-Control Unit Inputs and Outputs For 36P Connector

2009 Honda Pilot Touring, 3.5 4SECTION VSA Modulator-Control Unit Inputs and Outputs For 36P Connector
NOTE: Standard battery voltage is about 12V.
TERMINAL REFERENCE TABLE

Terminal number Wire color Terminal sign Description Signal
1 RED CAN-L F-CAN communication circuit -
3 LT BLU K-LINE Communication with HDS
4 LT GRN RR-GND Detects right-rear wheel speed sensor signal
6 GRY FL-GND Detects left-front wheel speed sensor signal
8 GRY/RED RL-GND Detects left-rear wheel speed sensor signal
9 YEL SVCC Power source for the steering angle sensor With ignition switch ON (II): about 5.0 V
10 PNK FR-GND Detects right-front wheel speed sensor signal -
11 BLK STR-A Detects steering angle sensor signal
12 LT GRN FSR+B Power source for the fail-safe relay Battery voltage at all times
13 RED MR+B Power source for the motor relay Battery voltage at all times
14 WHT CAN-H F-CAN communication circuit -
18 BRN RR+B Detects right-rear wheel speed sensor signal
19 ORN FL+B Detects left-front wheel speed sensor signal
21 YEL/RED RL+B Detects left-rear wheel speed sensor signal -
23 GRN FR+B Detects right-front wheel speed sensor signal
25 GRY WEN Detects write enable signal
26 BLU/ORN STR-D Detects steering angle sensor signal
27 PUR STR-B Detects steering angle sensor signal
30 ORN IG1 Power source for activating the system With ignition switch ON (II): about battery voltage
34 BRN/YEL SGND Ground for the steering angle sensor -
35 BLK GND Ground for the VSA modulator-control unit Continuity
36 BLK MR-GND Ground for the pump motor Continuity
Fig 1: Identifying VSA Modulator-Control Unit Inputs & Outputs For 36P Connector Terminal
G05962941Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.