Rear Control Panel Removal/ Installation

2009 Honda Odyssey EX-LSECTION Rear Control Panel Removal/ Installation
  1. Remove the rear control panel (A) from the roof.

    Rear climate controlΒ 

    Fig 1: Identifying Rear Control Panel (Rear Climate Control)
    G05526445Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Rear manual A/CΒ 

    Fig 2: Identifying Rear Control Panel (Rear Manual A/C)
    G05526446Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the connector (B) from the rear control panel.
  3. Install the rear control panel in the reverse order of removal. After installation, operate the various functions to see whether works properly.
  4. Run the self-diagnostic function to confirm that there are no problems in the system (see GENERAL TROUBLESHOOTING INFORMATION ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.