SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009ODYSSEY EX-LREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSIMMOBILIZER SYSTEMIMMOBILIZER CONTROL UNIT-RECEIVER REPLACEMENT
2009 Honda Odyssey EX-L

Immobilizer Control Unit-Receiver Replacement

2009 Honda Odyssey EX-LSECTION Immobilizer Control Unit-Receiver Replacement
  1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
  2. Remove the steering column covers (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  3. Disconnect the 7P connector (A) from the immobilizer control unit-receiver (B).
    Fig 1: Identifying 7P Connector, Immobilizer Control Unit-Receiver And Ignition Key Cylinder
    G05526865Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the two screws and the immobilizer control unit-receiver from the ignition key cylinder (C).
  5. Install the immobilizer control unit-receiver in the reverse order of removal.
  6. After replacement, check the immobilizer system.
  7. Using the HDS, select "Immobilizer Setup" from the "Honda System" menu, then select "Immobilizer control unit/receiver replacement".
  8. Rewrite the immobilizer control unit-receiver by following the instructions on the HDS, then check the immobilizer system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.