Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2009ODYSSEY EX-LREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEMXM RECEIVER REMOVAL/INSTALLATION

2009 Honda Odyssey EX-L

XM Receiver Removal/Installation

2009 Honda Odyssey EX-LSECTION XM Receiver Removal/Installation

Remove the left rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
Disconnect the antenna 2P connector (A) and 14P connector (B) from the XM receiver (C).

Fig 1: Identifying Antenna 2P Connector, 14P Connector And XM Receiver
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Loosen the three nuts and remove the XM receiver.
Install the XM receiver in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.