SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009ODYSSEY EX-LREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMIGNITION TIMING INSPECTION
2009 Honda Odyssey EX-L

Ignition Timing Inspection

2009 Honda Odyssey EX-LSECTION Ignition Timing Inspection
  1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on GENERAL TROUBLESHOOTING INFORMATION ).
  2. Turn the ignition switch to ON (II).
  3. Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  4. Check for DTCs (see HOW TO USE THE HDS (HONDA DIAGNOSTIC SYSTEM) ). If a DTC is present, diagnose and repair the cause before continuing with this test.
  5. Start the engine. Hold the engine speed at 3,000 rpm with no load (in N or P) until the radiator fan comes on, then let it idle.
  6. Check the idle speed (see IDLE SPEED INSPECTION ).
  7. Jump the SCS line with the HDS.
  8. Connect the timing light to the No. 1 ignition coil harness.
    Fig 1: Connecting Timing Light To No. 1 Ignition Coil Harness
    G05522626Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Aim the light toward the pointer (A) on the timing belt cover. Check the ignition timing under a no load condition (headlights, blower fan, rear window defogger, and air conditioner are turned off).

    Ignition Timing: 10° ± 2° BTDC (RED mark (B)) at idle in N or P 

    Fig 2: Identifying Pointer And Red Mark
    G05522627Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. If the ignition timing differs from the specification, check the cam timing. If the cam timing is OK, update the PCM if it does not have the latest software (see PCM UPDATE ), or substitute a known-good PCM (see SUBSTITUTING THE PCM ), then recheck. If the system works properly, and the PCM was substituted, replace the original PCM (see PCM REPLACEMENT ).
  11. Disconnect the HDS and the timing light.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.