Power Window Master Switch Replacement

2009 Honda Odyssey EX-LSECTION Power Window Master Switch Replacement
  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Remove the screw and disconnect the 23P connector (A) and 13P connector (B) from the master switch panel (C), then remove the switch assembly from the door panel.
    Fig 1: Identifying 23P Connector, 13P Connector And Master Switch Panel
    G05526692Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the four mounting screws, then remove the master switch (A) from the switch panel (B).
    Fig 2: Identifying Master Switch And Switch Panel
    G05526693Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install in the reverse order of removal.
  5. Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.