Vanity Mirror Light Test/ Replacement

2009 Honda Odyssey EX-LSECTION Vanity Mirror Light Test/ Replacement
  1. Carefully pry off the lens (A) with a small screwdriver.

    Vanity Mirror Light: 2WΒ 

    Fig 1: Identifying Vanity Mirror Light
    G05526666Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the two screws, then remove the vanity mirror light (B).
  3. Disconnect the two terminals (C) from the vanity mirror light.
  4. Check for continuity between the terminals.
    • There should continuity between the terminals with the vanity mirror cover opened.
    • There should be no continuity between the terminals, with the vanity mirror cover closed.
  5. If the continuity is not as specified, check the bulb or the light. If the bulb or light is OK, replace the sunvisor.
  6. Install in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.