SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 75 (NAVIGATION SYSTEM)SYSTEM DESCRIPTIONREARVIEW CAMERA INPUTS AND OUTPUTS
2009 Honda CR-V EX, 2.4 RE3

Rearview Camera Inputs and Outputs

2009 Honda CR-V EX, 2.4 RE3SECTION Rearview Camera Inputs and Outputs
WARNING: This page is about a different car, the 2011 Honda CR-V and 2010 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera 6P Connector Terminal Layout
G06612827Courtesy of AMERICAN HONDA MOTOR CO., INC.

Rearview Camera 6P Connector 

REARVIEW CAMERA 6P CONNECTOR TERMINALS REFERENCE CHART

Terminal Number Wire Color Terminal Name Description Voltage (about) Symptom
1 GRN VCC (VCC supply) Power source for rearview camera 8V If open: No rearview camera image.
If short to ground: When put into reverse, the navigation screen goes black (display backlight still operative).
2 WHT GND (Ground) Ground for rearview camera 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
3 RED CAMERA V GND (Ground camera) Ground for camera signal 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
4 BLK CAMERA V (Video camera) Video signal for rearview camera 0.3 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
5 GRY(1) CAMERA SH (Shield camera) Shield for terminals No. 1 to No. 4 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
6 BRN CAMERA ADPT (Adaptive camera) Control signal for rearview camera 0 V If open: No change to rearview camera image.
If short to ground: No change to rearview camera image.
(1) The shielded wires have a heat-shrink tube insulating the outside of the wire. The color of the insulating tube, typically black or dark gray, may not match the color of the wire shown on the circuit diagram.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.