Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 75 (NAVIGATION SYSTEM)REARVIEW CAMERA REMOVAL/INSTALLATION
2009 Honda CR-V EX, 2.4 RE3
Rearview Camera Removal/Installation
2009 Honda CR-V EX, 2.4 RE3SECTION Rearview Camera Removal/Installation
WARNING: This page is about a different car, the 2011 Honda CR-V and 2010 Honda CR-V. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the tailgate lower trim panel (see CARGO AREA FLOOR ).
- Disconnect the connector (A) from the rearview camera (B), then remove the wire harness clip (C).
- Remove the rearview camera.
- Install the rearview camera in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.