Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISFUEL SUPPLY SYSTEMFUEL FILL PIPE REMOVAL/INSTALLATION
2009 Honda CR-V EX, 2.4 RE3
Fuel Fill Pipe Removal/Installation
2009 Honda CR-V EX, 2.4 RE3SECTION Fuel Fill Pipe Removal/Installation
- Relieve the fuel pressure (see FUEL PRESSURE RELIEVING ).
- Drain the fuel tank (see FUEL TANK DRAINING ).
- Remove the fuel fill cap.
- Remove the fuel fill pipe cover (A) and the fuel fill cap adapter (B).
- Remove the left rear wheel and its wheel speed sensors (see REAR ).
- Support the rear differential (4WD model) and the rear axle beam with a transmission jack.
- Remove the flange bolts from the bottom of the rear damper/springs (see STABILIZER BAR REPLACEMENT ).
- Remove the rear differential (4WD model) (see REAR DIFFERENTIAL REMOVAL ) and the rear suspension subframe mounting bolts (see REAR SUBFRAME TORQUE ).
- Lower the transmission jack (A) and the rear differential or the axle beam.NOTE: Be careful not to damage the connecting parts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.