Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMDASHBOARDINSTRUMENT PANEL REMOVAL/INSTALLATION
2009 Honda CR-V EX, 2.4 RE3
Instrument Panel Removal/Installation
2009 Honda CR-V EX, 2.4 RE3SECTION Instrument Panel Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment Program; 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or related parts.
- Remove these items:
- Driver's vent panel (see DRIVER'S VENT PANEL REMOVAL/INSTALLATION )
- Center upper dashboard panel (see CENTER UPPER DASHBOARD PANEL REMOVAL/INSTALLATION )
- Instrument upper visor (see INSTRUMENT UPPER VISOR REMOVAL/INSTALLATION )
- Gently pull up the instrument panel (A) by hand from the driver's vent panel and center upper panel openings to release the clips. Disconnect the automatic lighting sensor connector (B), if equipped.
- Install the panel in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the automatic lighting sensor connector is plugged in properly, if equipped.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.