Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMDASHBOARDDASHBOARD CENTER VENT REMOVAL/INSTALLATION
2009 Honda CR-V EX, 2.4 RE3
Dashboard Center Vent Removal/Installation
2009 Honda CR-V EX, 2.4 RE3SECTION Dashboard Center Vent Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
* Available through the Honda Tool and Equipment Program; 888-424-6857
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or related parts.
- Remove the center upper dashboard panel (see CENTER UPPER DASHBOARD PANEL REMOVAL/INSTALLATION ).
- From the center upper dashboard panel opening, pull the edges of the dashboard center vent (A) slightly toward you to release the clips.NOTE: If the vent is pulled upward, the audio panel (B) will be damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.