Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHONDA2009CR-V EX, 2.4 RE3REPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMDASHBOARDDASHBOARD CENTER LOWER COVER REMOVAL/INSTALLATION

2009 Honda CR-V EX, 2.4 RE3

Dashboard Center Lower Cover Removal/Installation

2009 Honda CR-V EX, 2.4 RE3SECTION Dashboard Center Lower Cover Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

* Available through the Honda Tool and Equipment Program; 888-424-6857

NOTE:

Put on gloves to protect your hands.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to scratch the dashboard or related parts.

Remove the front console cover, both sides (see FRONT CONSOLE COVER REMOVAL/INSTALLATION ).
Remove the screw.
Gently pull out upper of the dashboard center lower cover (A) to release the clips, then remove the cover.

Fig 1: Identifying Dashboard Center Lower Cover And Front Accessory Power Socket Connector
Disconnect the front accessory power socket connector (B).
Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the connector is plugged in properly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.